PLEATED SHADES WITH CONTROL HANDLE FOR VERTICAL WINDOWS (UP TO 15°)

Description

Amigo pleated shades of this series are designed to be installed both outside and inside of standard openings as well as on tilt and turn windows with slope angle up to 15°.

These are the tension-type models with the shade structure fixed at the top and at the bottom (on a window shoe bracket and/or a fixed rail)

Rectangular or complex-shaped models

Day/night models involving two fabrics differing in density/texture/color

Models with one or two movable rails

Closed system of cords tensioning with springs

The shade is controlled via the handle on the movable rail / pair of handles on two movable rails: An additional handle is installed on the movable rail if the shade width exceeds 80 cm

The textile sheet may be fixed at any given level.

The product hight may vary within the allowable range of ± 5 – 10 mm (depending on the fabric)

Fig. 131

BROWN

For limit dimensions of the complex-shaped models refer to the Book of Seller

Options

• Dimension type: of a product (default) or an opening.

Product - dimensions of rectangular products will correspond exactly with those specified in the request. Dimensions of complex-shaped products will correspond to the model configuration.

Opening - dimensions of rectangular products will be reduced by 2 mm from either side to fit inside the opening.

• Adjusting key: yes or no (default). It is used to fit the products inside deep (exceeding 15 mm) and skewed (15 degrees) fillets. It is utilized only for the models with no window brackets.

• Face: outside or inside (default).

Outside - fabric face will be on the side of the glass

Inside - fabric face will be inside the premises

• Magnetic bracket: yes or no (default). It is used only for the models with the window bracket.

• Bracket type: depends on the installation location.

• Handle type: plastic (default) or metal.

Plastic - standard handle compatible with a handle extention

Metal - fixed handle with a metal silver case and an insert in the color of fittings. It is not compatible with the handle extension.

• Reinforced profile: yes or no (default). It is recommended for the products with great width including non-warranty one.

• Cord with loops: yes or no (default). It is used for equal distribution of the fabric folds along the product height. It is used only for the rectangular models. It is fitted only at the product fabrication stage behind the fabric sheet. Its further fitting inside the ready-made product is not possible.

• Handle extension: 1.0 m, 1.5 m, 2.0 m, none (default). It is used to operate high or highly installed products. It is only compatible with the standard plastic handle.

• Color palette: white, silver, bronze., brown (plugs and brackets are black)

Additionaly

There are no additional designs

Measurement and installation

View/download measurement instructions

View/download installation and operation instructions

Fittings colors